IPsec VPN WAN2

[raein28]

Hi,

Would like to ask some help regarding IPsec VPN setup using wan2. 1 site is behind NAT and the other is facing public.

Scenario:

Main - Wan1 behind NAT and admin network uses for internet.

          Wan2 will be use for IPsec VPN to branch

Branch - Wan1 behind NAT and admin network

Issue, i cannot seems to enable Main Wan2 facing public. Where can i set the gateway for this wan2 if it is in manual mode?

Default route is already set for network to use Wan1 for internet.

Regards.

[raein28]

Hi Everyone,

Just an update. I was able establish the site to site vpn using the wan1. Both are behind NAT. The issue now is i cannot access the branch host.

Main Lan Interface ip is different subnet from host ip behind the fortigate.

Branch Lan interface ip is same subnet with host behind it.

Main - Routing is handled by a different server. on which i have already added the routing config.

I think im missing something here.

Hope someone helps.

Thank you