Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Deftone
New Contributor

IPSec native win client

Hi,

 

I just upgraded my 100E to 7.0.3 OS release.

 

What I see is that the dial up IPSec created with wizard for native win client doesnt work anymore?

I can connect but can not reach anything on the other side.

 

When I roll back to 6.4.8 everything is working fine again.

Any idea what has changed and how to resolve it? I have all policies set

1 Solution
pkavin
Staff
Staff

Hello,

 

It is not clear from your notes if you are using IKEv1 or IKEv2 with the Windows Native Client. But, I am assuming you are using L2TP over IPSec (which uses IKEv1) and that needs some manual configuration change as mentioned in the below document after upgrading device to FortiOS 7.0.3 

 

https://docs.fortinet.com/document/fortigate/7.0.3/fortios-release-notes/927994/l2tp-over-ipsec-conf...

 

 

Kavin

View solution in original post

3 REPLIES 3
pkavin
Staff
Staff

Hello,

 

It is not clear from your notes if you are using IKEv1 or IKEv2 with the Windows Native Client. But, I am assuming you are using L2TP over IPSec (which uses IKEv1) and that needs some manual configuration change as mentioned in the below document after upgrading device to FortiOS 7.0.3 

 

https://docs.fortinet.com/document/fortigate/7.0.3/fortios-release-notes/927994/l2tp-over-ipsec-conf...

 

 

Kavin
Deftone
New Contributor

Thanks that helpded a lot.

I had policy's set from wrong source interface 

pkavin

You're welcome

Kavin
Labels
Top Kudoed Authors