IPSEC VPN Setup help?

[doodguy]

Hello,

I am trying to setup an IPSEC VPN on a Fortigate 200b, but it isn't working. I created a user "test" and assigned them to group "VPN Users"

I then went into VPN and did the VPN wizard. Now I tried this twice, and have 2 VPN tunnels listed, but am unable to delete them for some reason. Delete is greyed out. At any rate, when I went through the wizard, I set my Incoming Interface as the WAN interface, Client Address Range 10.3.0.50-10.3.0.254, subnet mask 255.255.255.0; checked enable IPv4 Split Tunnel, and set Accessible Networks to Local_Lan which is an object I created with IP range 10.2.1.0/24.

Under the forticlient software, I clicked IPSEC VPN, set the remote gateway to my public IP, did a pre shared key the same as I did in VPN setup, set authentication to save login, but when I try to connect to the vpn it says connecting for about 20 seconds, then comes back with "VPN Connection failed. Please check your config"

I set log level to debug but it has a bunch of stuff which I don't really understand.

Could someone please point me in the right direction?

[gschmitt]

doodguy wrote:

Could someone please point me in the right direction?

May I point you to this https://www.youtube.com/watch?v=5MIrgkFcuW0 ?

If you can't delete the old tunnels it's because other items reference them, you need to identify and delete those first