1.) Have IPSEC tunnel up. (Showing in VPN-> Monitor as up.)
2.) Have seven "remote" subnets, and three "local" IP addresses. For ease of explaining, let's call them 10.1/16, 10.2/16, 10.3/16, 10.4/16, 10.5/16, 192.168.5/24, and 192.168.6/24. And then the IPs would be 10.1.11.5, 10.0.1.5, and 10.0.1.6.
3.) Objects created for each single listing above. (ie, Remote1, Remote2, Remote3,...IP1, IP2, IP3.)
4.) Groups created for each "set". REMOTE_GROUP. IP_GROUP
5.) Bi-directional policies setup.
5a.) Source: REMOTE_GROUP Dest: IP_GROUP <Always, all, accept>
5b.) Source: IP_GROUP Dest: REMOTE_GROUP <Always, all, accept>
Now...here's the weird part. If they attempt pings from their site? Remote1, Remote3, Remote5, and Remote6 will work to ping IP1. Remote2, Remote4, and Remote7 will get a timeout error with the classic "The packet specifies its destination as..." Which is usually an ACL error in the Phase 2 setup, but we've both confirmed that the subnets match, and all looks good...
I'm stumped. Any thoughts? Advice? Anecdotes?
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Odd, that sounds almost like WAN LLB or ECMP.
The cli diag debug flow is your 1st step. Also if these are route-base make sure you have ....."a route" ;)
PCNSE
NSE
StrongSwan
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.