IPSEC Tunnel Change remote gateway

[Anda]

Hi,

i have a VPN Ipsec between a 30E and 60D already working. So far, so good.

Now, we need to change Wan line, from 30E. So, i have to change remote ip in 60D. And i have also changed preshared key, as i do not remember it. Obviously, i have changed the preshared key in 30E and 60D.

But, surprise, for me, sure, the tunnel goes up, but no traffic flows.

Back to old gateway, all is ok!

So, i need help... what should i do in this case?

Many Thanks,

            Antonio

[ede_pfau]

hi,

it might well be that there is an old session still active in the session table. I think if you disable the corresponding policy and re-enable it it's sessions will be terminated (quicker than some diag command...).

Of course, you could always just reboot the 60D as well.