IKE routes Priority.

[j1ades]

Hi all I’m looking to adjust the priority of IKE routes, which according to CLI guidance should be a command under ipsec phase1-interface, set priority x.

But the command/option doesn’t seem to exist. This is an advpn / bgp on loopback configuration on the spoke side. Im looking to amend the priority of IKE routes for the hub loopback when learned over a cellular overlay to avoid BGP establishing in that direction.

I’m assuming another command is required as a pre req but my brain is drawing a blank on this one.

Any help much appreciated.

Thanks

[distillednetwork]

Have you looked at applying a route-map to apply a different weight for the neighbor ip that would apply to the cellular bgp routes?