I use the Fortigate 200e and firmware is ver.6.0.6. I wanna build SD-WAN with wan port1 an

[ms5080]

Hi

I use the Fortigate 200e and firmware is ver.6.0.6. I wanna build SD-WAN with wan port1 and 2 which are pppoe ISP using. But open SD-WAN configration, cannot select of interface wan1 and 2.(don't display)

Please kindly help above issue.

Thank you.

[Jirka1]

Check dependencies. You must not have any Policies, routes etc. set before adding to the SD-WAN.

J.

[simonorch]

I would seriously consider patching to the latest release of 6.4, so much development has been done with sd-wan since 6.0, and please do yourself a favour and patch to the latest 6.0 at the very least, if no other reason than patching of CVE vulnerabilities.