Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I found netlink error but I dont know cause
Hi, I'm engineer from Korea
When I was check Client system I found interfaces error
But I don't know cause
Could I get Help?
Device - Fortigate-80E
Firmware - v6.2.8
Labels:
- Labels:
-
FortiGate
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
0.0001% errors can be safely ignored
AEK
AEK
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If that '1' is the third number in the line after the interface name in "diag netlink device list", it's the number of errors on receiving side. It could happen for many reasons, like when you unplug and replug it in. So most important thing is if the number increases. Just keep running the command repeatedly to see if it changes.
If stays as '1', I would call it good.
Toshi
