Hello, as you may know, I've had a case about setting up outgoing IP address to use BGP router ID, the response was here and here. So I disabled the NAT on this interface, and for now, it shows correctly outgoing address from the network like A.B.C.190 but every incoming traffic that I see is exactly A.B.C.190, not the real IP address like 1.2.3.4, 8.8.8.8, 11.15.13.12, 62.12.233.15 etc... so it is very hard to monitor this. Of course on Fortigate I can see the Source and Destination, but when the traffic goes to LAN it always is A.B.C.190 from the Internet.
Thanks in advance for replies.
Ok, I've managed to discover that this is the same issue ;-). Just disable NAT on IF and it works.
Thanks.
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1846 | |
1130 | |
769 | |
447 | |
260 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2025 Fortinet, Inc. All Rights Reserved.