Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Sanj
New Contributor

How to end scrolling Fortigate - 50B

Hello, 

I am new to Fortinet world. I am using Fortigate 50B and wanted to see the full config; did so by using "show" command. After getting enough info wanted to get out of that show page so used Ctrl + C also tried Ctrl + Z key; however it just logged me off. I Know that we have to use end command on fortigate but this one was on half page still showing much more info and i couldn't use  end command. Is there any short key to get out of the current show page without being logged out? 

 

Thank you.

1 Solution
ede_pfau
SuperUser
SuperUser

That depends on the firmware used. As the 50B is old your FortiOS might not have these commands (try it anyway):

config system console

   set output more

end

Now output will stop after one screenful. You continue with ENTER, and quit with Q.

 


Ede


"Kernel panic: Aiee, killing interrupt handler!"

View solution in original post

Ede"Kernel panic: Aiee, killing interrupt handler!"
2 REPLIES 2
ede_pfau
SuperUser
SuperUser

That depends on the firmware used. As the 50B is old your FortiOS might not have these commands (try it anyway):

config system console

   set output more

end

Now output will stop after one screenful. You continue with ENTER, and quit with Q.

 


Ede


"Kernel panic: Aiee, killing interrupt handler!"
Ede"Kernel panic: Aiee, killing interrupt handler!"
Sanj
New Contributor

Thank you, it worked !

Labels
Top Kudoed Authors