- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How to configure 2 ip on for site to site vpn remote gateway
As above. The remote site VPN GW has 2 ip addresses. SO how do I configure it?
Solved! Go to Solution.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may use ikev2 with network overlay enabled and different network IDs to meet your requirement. Follow this KB https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-establish-more-than-one-IPsec-tunne... as a guide.
Paulo Ginete
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @BusinessUser,
I don't think it is possible to configure 2 IP addresses for remote-gw in the same tunnel.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Firstly, what for you will use 2 remote gw?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
for redundancy like 8.8.8.8 and 8.8.4.4
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may use ikev2 with network overlay enabled and different network IDs to meet your requirement. Follow this KB https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-establish-more-than-one-IPsec-tunne... as a guide.
Paulo Ginete