How select next hop for bgp control plane message incase ECMP Route via ike/32 Injection

[sk4]

I have three static routes to reaching my bgp Neighbour via ipsec tunnel by using ike/32 injection with same AD,metric and priority how fortigate will select the best path for bgp control plane message.
@Jean-Philippe_P @msingh_FTNT @Anthony_E 

[Anthony_E]

Hello,

Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.

Thanks,

[Anthony_E]

Hello,

We are still looking for someone to help you.

We will come back to you ASAP.

Thanks,

[Anthony_E]

Hi,

Did you have a look at this KB article?:

Technical Tip: ECMP routes for recursive BGP next hop resolution

Regards,

[sjoshi]

Hi @sk4 ,

can you share the routing table output

get router info routing-table details x.x.x.x >> where x.x.x.x is the neighbor IP and let me know which interface it should take

[Toshi_Esumi · Accepted solution]

Since those are three static routes for the same destination, it would be load balanced based on "v4-ecmp-mode" setting under "config sys settings". But once the first packet establishes a session I wouldn't expect the path changes unless the session times out.

Toshi

[sk4]

Thanks for sharing this. but incase of SDWAN enabled, "v4-ecmp-mode" setting under "config sys settings" is not available as its moved under config system sdwan under set load-balance-mode.

[Toshi_Esumi]

I see. You never mentioned you use SD-WAN. 
Or, maybe my knowledge is old and all FGTs now have SD-WAN enabled and the balancing setting is under SD-WAN config by default.

Toshi