Help with WAN setup 100f

[terrence278]

I recently installed a 100f with two WANs but one of them will not ping and I cannot setup any IPsec tunnels with it or use it for sslvpn as the interface. The interface shows up and I'm able to ping the modem behind it but I'm at a loss and I'm sure it's a simple thing Im not aware of https://mobdro.bio/ .

Sdwan was setup for the interfaces and grouped together. I set the default route to this group and the priority and Admin Dist is default, very basic currently.

Previously I migrated these connections and conf from a Sophos XG which, when I moved the connections back to confirm, both WANs were pingable.

Yes I confirm ping was enabled on the interface, I'm guessing this is a route issue but Im not sure where to look.

Thanks for your help sorry for the wall

[tachen]

These docs may help, in short, make sure you configured two static routes (router static entries in CLI) with same distance.

https://community.fortinet.com/t5/FortiGate/Technical-Note-Routing-behavior-depending-on-distance-an...

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Setting-priority-on-static-default-routes-...