Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
dirkdigs
New Contributor

HA Wan speeds are slow

Hello , i have setup 2 FGT 200's in HA mode , active/standby

our wan 1 connection is 200 Mbps download 

 

When i run a speed test i am only getting about half. AKA 100 Mbps download

 

i have the WAN connection and the 2 FGT WAN ports connected to a Cisco switch with the 3 switch-ports in isolated vlan . 

 

did i miss anything? Does that sound like the correct configuration?

2 Solutions
julienlux
New Contributor III

Ok, do you have some UTM Feature on your policy ( App Control, AV, IPS ..... )

 

What's your hardware? A 200B, 200D, 200E ?

View solution in original post

julienlux
New Contributor III

For testing purpose can you try to disable all this feature on the policy (or create a new one only fromyour computer ip) and do a speed test again? Normally the lowest throuput of your device should be 820 Mbps but datasheet and real life are not the same.

View solution in original post

5 REPLIES 5
julienlux
New Contributor III

Does you WAN connection connected to a 1GB port or 100MB port? Do you have some UTM features on your firewall policy?

dirkdigs

its a 2.5 GB port actually . 

 

CAT 9300

julienlux
New Contributor III

Ok, do you have some UTM Feature on your policy ( App Control, AV, IPS ..... )

 

What's your hardware? A 200B, 200D, 200E ?

dirkdigs

201E

yes

 

web,app, AV,DNS,SSL(certificate-inspection) all defaults. 
julienlux
New Contributor III

For testing purpose can you try to disable all this feature on the policy (or create a new one only fromyour computer ip) and do a speed test again? Normally the lowest throuput of your device should be 820 Mbps but datasheet and real life are not the same.

Labels
Top Kudoed Authors