- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Full Mesh VPN
Hi,
I'm new in this world, but I got a project where I need to connect some Fortigates between a VPN connection.
I have researched a lot, but I'm a bit confuse. In fact, I need to connect every Fortigate with all of the rest of the company, but they need to maintain communication if that link were broken. I mean, set up the Fortigate to choose dynamically which tunnel is the best one to go.
I think I already know how to do the tunneling, but I'm not sure if only connecting them by a Full Mesh topology of tunnels they will have that redundancy.
Thanks and Regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
So I need to configure a routing protocol in the Fortigate?
Thanks for answering.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I didn't mention an important aspect when I posted my reply from an airport about to get on my flight 7 hrs ago.
The topology of network doesn't have to be full mesh depending on how many failures the network can tolerate in addition to how many locations(nodes) you have, like one circuit down, two circuit simultaneous downs, and so on. For example, a ring topology like A<->B<->C<->D<->A can cover a single circuit failure as long as the routing protocol is working properly. That's a fun part of network design :)