- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fortiswitch Port Update Problem
Hello. Fortigate has versions 7.0.15 Fortiswitch 7.4.2. They are interconnected with Fortlink. My problem is the following. I plug machine A into any port of Fortiswitch. Then I unplug this machine and plug machine B into the port. When I check in Fortigate, both machine A and B appear on the port when only machine B should appear. What is the reason for this?
- Labels:
-
FortiGate
-
FortiSwitch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
It is possibly because FortiGate holds the device info for quite some period of time in history when its idle/unavailable before they are removed , there is a config in system setting "discovered-device-timeout" that can be set to a day at minimum.
Best regards,
Jin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't quite understand what you mean. When I pull the computer from the port, I don't want the computer to appear under the port.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is the general problem with Fortigate in ver. 7.Was discussed here one link below
Fortiswitch show devices multiple times on single port . IN my case is exactly the same . device moved between ports and if you change vlan on the same ports.
I'm also waiting for solution because now only one way is just rebooting switch.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@plsikk We solved the problem on that. https://community.fortinet.com/t5/Support-Forum/Fortinac-F-Multiple-Host-Problem/m-p/358922#M256929