Fortiswitch/Fortilink, config snmpv3 Read and Read/Write user

[jmhalegre]

Hi Team,

I have several Fortiswitches managed via Fortilink, and I need to configure snmpv3 with one Read and one Read/Write user.

This configuration must be done from Fortigate?

Can you provide me the steps to follow to perform this configuration.

Thanks and best regards,

Juanmi

[vasilisgogos · Accepted solution]

Hi,

1- Configure custom commands:

config switch-controller custom-command
edit "snmp_access"
set command "config system interface %0a edit internal %0a set allowaccess https ssh ping snmp %0a end %0a"
next
edit "snmpv3"
set command "config system snmp user %0a edit SNMPV3_USER %0a set notify-hosts SNMP_Server_IP %0a set queries enable %0a set query-port 161 %0a set queries enable %0a set query-port 161 %0a set security-level auth-priv %0a set auth-proto sha1 %0a set auth-pwd Auth_Password %0a set priv-proto aes128 %0a set priv-pwd Priv_Password %0a end %0a"
next
edit "snmp_location"
set command "config system snmp sysinfo %0a set location Location %0a set status enable %0a end %0a"
next
next
end

2- Push commands to managed FSW

config switch-controller managed-switch
edit "FSXXXXXXXXXXXXX"

config custom-command
edit "0"
set command-name "snmp_location"
next
edit "1"
set command-name "snmp_access"
next
edit "2"
set command-name "snmpv3"
next

end

3- Repeat the second step for all FSW

Vasilis