- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fortinet lab setup
Hi everyone,
I have come here for doubt clearing a simple lab setup. I just want to understand how to configure LACP ( Etherchannel) between Fortinet and cisco switch along with what else configuration should I configure for better service.
In my lab setup, there are around four subnets and Vlans that belong under the LAN zone.
10.1.1.0/24
10.1.2.0/24
10.1.3.0/24
10.1.4.0/24
here is the LAB digram-
Request you to please recommend me how to configure LACP and trunking between the Fortinet FW and cisco switches.
As you can see that there are HA concepts -
Fortinet FW 1 & Fortinet FW2
Core-SW1 and Core-SW2
Thank you
Umesh
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Umesh,
On FortiGate end, the lacp bundle is bound to each Fortigate device, therefore you must bundle the port G0/0 of core-sw1 and G0/1 of Core-sw2 together and likewise. Please refer Technical Note : FortiGate HA A-P (Active-Passive)... - Fortinet Community for some additional info.
Best regards,
Jin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I don't see much difference from your previous post.
LACP needs to establish neighboring between two parties. The best way is still stacking two switches into one as Jin said above.
Toshi