Fortinet Fiber Transeiver not showing UP

[RolandBaumgaertner72]

Hi,

I dont get an original Fortinet Fiber Transeiver UP in networks. We have a FG200F cluster (7.0.13) and we would like to use this conncetion for HA heartbeat Interface and HA Monitor Interface with X1 and X2.

Checking the hardware on CLI I get;

XXXXX_HA2 # diag hardware deviceinfo nic x2
Description :FortiASIC NP6XLITE Adapter
Driver Name :FortiASIC NP6XLITE Driver
PCI Slot :PCI Bus 0000:01
irq :26
Board :200F
lif id :25
lif oid :89
netdev oid :89
Current_HWaddr 00:09:0f:09:00:1b
Permanent_HWaddr 80:80:2c:22:79:0b
========== Link Status ==========
Admin :up
netdev status :down
autonego_setting :1
link_setting :1
speed_setting :10000
duplex_setting :0
Speed :0
Duplex :N/A
link_status :Down
============ Counters ===========
Rx Pkts :0
Rx Bytes :0
Tx Pkts :0
Tx Bytes :0
Host Rx Pkts :0
Host Rx Bytes :0
Host Tx Pkts :0
Host Tx Bytes :0
Host Tx dropped :0
FragTxCreate :0
FragTxOk :0
FragTxDrop :0

XXX_FG200_HA2 #

Strange thing is that with Cisco Transeiver we get the message that it is not certified but it works fine:

XXX_FG200_HA2 # diag hardware deviceinfo nic x1
Description :FortiASIC NP6XLITE Adapter
Driver Name :FortiASIC NP6XLITE Driver
PCI Slot :PCI Bus 0000:01
irq :26
Board :200F
lif id :24
lif oid :88
netdev oid :88
Current_HWaddr 00:09:0f:09:00:1a
Permanent_HWaddr 80:80:2c:22:79:0a
========== Link Status ==========
Admin :up
netdev status :up
autonego_setting :1
link_setting :1
speed_setting :10000
duplex_setting :0
Speed :10000
Duplex :Full
link_status :Up
============ Counters ===========
Rx Pkts :1497
Rx Bytes :844711
Tx Pkts :1456
Tx Bytes :851673
Host Rx Pkts :1499
Host Rx Bytes :824855
Host Tx Pkts :1458
Host Tx Bytes :852843
Host Tx dropped :0
FragTxCreate :0
FragTxOk :0
FragTxDrop :0

XXX_FG200_HA2 #

We tried also with other cables and they are new.

What can we do?

Thanks,

Roland

[RolandBaumgaertner72]

Hello,

it is working on port 23, is there anything that in the X ports it would not work?