- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fortinet 60e doesn't boot?
Hi,
This is JUST out of support, and I attempted to factory reset it, as I intended to play with it. When I did so, it no longer booted up. Then, when I tried a different clover lead, it powered up for about...1 second, and then it stopped again. What can I do in this situation? I can't also connect to it via serial too given it simply won't power up. I have tried nonetheless however.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
It appears that it might be bricked, judging from what you've said.
Connecting the serial cable a power-cycling it should give you some kind of output on you terminal.
Do you confirm that there is absolutely nothing on the screen?
If so, from the little experience I've had RMA is the solution. But you say that support is just expired as well.
Without any output you will not be able to do much.
Let us know how it goes.
Carlitos loves firewalls
NSE4 (5.4,6.0)
NSE5 (Fortimanager 6.0, Fortianalyzer 6.0)
NSE7 (Enterprise Firewall 6.0)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Lunhas2k4 wrote:That's what I did and there was no output to the screen, so unsure of what else I can do? Thanks
Hi, It appears that it might be bricked, judging from what you've said. Connecting the serial cable a power-cycling it should give you some kind of output on you terminal. Do you confirm that there is absolutely nothing on the screen? If so, from the little experience I've had RMA is the solution. But you say that support is just expired as well. Without any output you will not be able to do much. Let us know how it goes.
