Fortinac DHCPD service stops working

[SamK0]

Hello everyone,
I have a problem with the DHCP service no longer working after reconfiguring fortinac using the configuration wizard.
I tried to restart it via cli but without success.
Can you help me?

[ebilcari · Accepted solution]

The ConfigWizard will generate a DHCP configuration file each time it will run. Please run and check the configurations in the ConfigWizard for any overlapping or mismatching subnets and pay attention for any errors shown in red before applying the changes.

Successful write to file /etc/dhcp/dhcpd.conf.test

[SamK0]

Hi Ebilcari, 
I found the error.
The problem was that when I used the ConfigWizard, it didn't write the IP of eth1 on port2. I manually entered the ip on port2 and the dhcp service was able to restart.
Thanks !