Fortimanager on Hyper-v upgrade from 6.0.3 to 6.0.5.

[jdixon]

I just upgraded from 6.0.3 to 6.0.5 and now the system doesn't have a NIC. I couldn't really find anything on correcting this but looking in CLI (through Hyper-V) I see the route and the ip address is set. The device can't even ping the gateway so I assume it is due to the linux OS not recognizing the NIC.

Any idea on how to correct this?

[jdixon]

I ended up setting the IP again and it started working.

I ran:

[ul]

config system interface

edit "port1"

set ip xxx.xxx.xxx.xxx 255.255.255.0

end[/ul]

Then it started working again. Before that I did a SHOW and it did show the correct IP so I change it to a different IP, then changed it back.