Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Kaplan
Contributor

Fortimanager exe central-mgmt register-device

Dear People,

 

I have some trobule with FabricConnectors FortiManager over CLI

 

I set up the

 

config system central-management

set type fortimanager

set fmg "fortimanager.forticloud.com"

end

 

exe central-mgmt register-device *serialnumber* *fmg-register-password*

 

Then I can see the FG to Authorization in Fortimanager

So I start the  authorization with error:

"Cannot communicate with remote device (tunnel is down)"

There is a solution to set the EMC to low (set enc-algorithm high), but this depends all VPN Tunnels.

*fmg-register-password* I use here the login password for Fortimanager. Is that correct or must I create a register password? If yes, how does I create it?

10 REPLIES 10
Toshi_Esumi
Esteemed Contributor III

Not sure what's going on other than suspecting the quality of connection over the internet. But I can at least tell the "password" at the end of the command is currently not used by FMG (AFAIK with 6.4.7) so we use any dummy one like "preshared-key" or whatever. You just need to have something there.

 

Just make sure fgfm(CLI)/FMG-access(GUI) is enabled on the wan interface(s) and test quality of connection with pinging from both ends.

 

Toshi

Kaplan

Hello Toshi,

thanx for your answer.

I tried it with a dummy password. You are right. I have a new device for authorization but the follow is the same. The authorization hangs.
If I do this over the GUI, there are no problems.
I am not sure that I understod you about "Just make sure fgfm(CLI)"

Kaplan_0-1649104741871.png

 

Toshi_Esumi
Esteemed Contributor III

I was talking about the FGT local config.

 

config sys int

  edit wan1

    set allowaccess ping fgfm

  next

end

In the GUI, under Network->Interface->wan1 under Administrative Access section then FMG-Access checkbox for IPv4 and IPv6.

Kaplan

After factory Reset I check it. This settings are default. 
But my problem are the same:-)

Kaplan

Now I try it over gui; there is no problem.

Toshi_Esumi
Esteemed Contributor III

Just curiosity. What version of FortiOS running on the FGT(s)? And what's the version of FMG?

Kaplan

FG: 6.4.8

FMG 7.0.5
I found 
https://community.fortinet.com/t5/FortiManager/Technical-Tp-How-to-register-a-FortiGate-to-a-FortiMa...

You can set a register-password on Fortimanager, but there are no change 

Toshi_Esumi
Esteemed Contributor III

I would recommend opening a case at TAC.

Kaplan

I will do it

 

Labels
Top Kudoed Authors