- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fortimail in HA active-pasive mode
I will have to deploy in a few days two fortimail units in ha, active pasive mode.
I was reading on the internet and found the video ( http://cookbook.fortinet.com/how-to-configure-active-passive-ha-mode-in-fortimail-video/ ) on fortigate cookbok website but I can not understand how should the heartbeat interface and the mail traffic interface be configured.
In the example scheme port1 is used for mail traffic and port5 and port6 for heartbeat but the configuration shows nothing about heartbeat interfaces.
Can you help me ?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
video is just an approach to setup;
better go the Fortimail-admin-523.pdf at http://docs.fortinet.com/fortimail/admin-guides
Page 300+ has a step by step procedure for an example as yours.
You'll need address for the interface you'll use as hearbeat; and use it thereafter in HA config
hope it helps
regards
/ Abel
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Abel,
Thanks for the information,
How can we check the HA Synchronization of data between the Active-Passive unit for the Fortimail unit.
Regards,
Vasif
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Vasif
diag system ha showcsum
You could also check that directly from webGUI
regards
/ Abel