- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fortigate unexpectedly reboot after removing SSID
Hello, Do you have any information about the new bug in the latest version of Fortigate 7.0.9?
In short when I remove the SSID from Fortigate then I notice that I lose the connection to Fortigate, also I see how Fortigate has been rebooted unexpectedly, after reboot I wait for the check disk before getting the Fortigate back. The Fortigate is 601F I identified these logs on the system events.
Message Fortigate had experienced an unexpected power off!
Message Unsafe reboot may have caused inconsistency in disk drive. Please run execute disk scan 17
I did found this release note for 7.0.9 but there I don't see bug with this behaviour:
Known issues | FortiGate / FortiOS 7.0.9 (fortinet.com)
Any one with the same issue in 7.0.9?
Also which version is stable in the current moment for Fortigate 601F?
I see this behavior when the SSID is in Bridge mode.
Thank you in advance.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
You may consider to connect PC to both FortiGates via console cable and run the commands below, try to reproduce the issue and check the output:
diagnose debug kernel level 7
diagnose debug console timestamp enable
diagnose debug duration 0
diagnose debug enable
Created on 02-15-2023 10:51 PM Edited on 02-15-2023 10:52 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thank you for the commands.
We opened case to Fortinet.
FYI
The bug is occurs only when deleting SSID from GUI.
When we remove SSID from CLI we don't see any issues.
Best Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You can also try this command, as it will give some more information.
#diagnose debug crashlog read
the "read" option will probably not be listed as an option but it WILL work if there is a crashlog to show. So go ahead and type "diag debug crashlog read" even if "diag debug crashlog ?" does not show "read" as an option.
regards,
Sheikh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sheikh ,
Thank you for joining to the topic.
I am new with Fortigate, please could you share your experience regarding the stability of the Fortigate devices and their OS?
Should I expect multiple bugs?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
New Update is available.
Known issues | FortiGate / FortiOS 7.0.10 (fortinet.com)In the release note I see answers for the most identified bugs with unexpected reboots.
Best Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This just happened to me yesterday - running 7.2.5