Fortigate to StormShield (NETASQ) VPN (ipsec s2s )Setup

[YtseJam]

Hi All,

I just can't establish a VPN (ipsec s2s) tunnel on my fortigate to our remote sites that has a StormShield (NETASQ) firewall. Does anyone tried it already using those two medium mention above to establish a vpn tunnel? Please advise. Refer to attached files for my config. Thank you.

Regards,

JAM

[gschmitt]

In the CLI (with putty for example)

diag debug reset

diag debug enable

diag debug application ike -1

Capture the output

[YtseJam]

where do I need to run that commands, in fortigate's CLI? I tried it, but no results.