- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Fortigate Ram Upgrade
I have 2 firewalls model 1101E. It has a total of 16 GB ram, 8 + 8. What kind of problem will I have if I remove these rams and replace them with 16 + 16 gb total 32 gb ram with the same feature?
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ideally we need to investigate why the current RAM is not enough to handle your network traffic and optimize the same. Opening a TAC ticket to investigate this will be the best method.
Regarding RAM upgrade, below discussions may give you some details.
https://www.reddit.com/r/fortinet/comments/b9o9cr/fortigate_400e_upgrade_ram/
https://community.fortinet.com/t5/Support-Forum/Increase-Fortigate-RAM/m-p/131798
Suraj
- Have you found a solution? Then give your helper a "Kudos" and mark the solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
bcm.user and ipsengine services sometimes use too much memory. i can't figure out why. this puts the device into converse mode.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
do you see anything in crashlog "diag debug crashlog read" ?.
Suraj
- Have you found a solution? Then give your helper a "Kudos" and mark the solution.