Fortigate 500D - Many clients to one NAT

[RolfW]

Hello there,

I am new to this forum and to Fortigate. Now I have a question about NAT. We should reach some IPs over RDP, is it possible to create a rule which NAT many clients (CMP001, CMP002, etc.) to one public IP Address?

Rule:

Incoming Interface: inside

Source Address: CMP001, CMP002

Outgoiing Interface: outside

Destination Address: IP-Range 62.1.2.3 to 62.1.2.7

NAT -> Using Dynamic Poool: 194.77.66.50

Or what must I do? Thank you. Regards, Rolf

[Nils]

That seems to be correct.

The rule will do the following:

When the Source is CMP001,002

AND 

The destination is 62.1.2.[3-7]

The source will change to the IP's in the pool.

If you only got 1 address in the pool, then this address will be used for this traffic.

[RolfW]

Hello,

for both or only for the first you get connected?

Thank you.