Fortianalyzer ntp sync

[Jin-Gyu]

Hi.

I can't sync with the ntp server after using executetime xx:xx:xx in Fortianalyzer.

It is the same even if the ntp status is disabled and enabled.

Is there an ntp sync command on Fortianalyzer?

In the case of Fortigate, I can find out when it was last synced through the 'execute time' command, but how do I check it in Fortianalyzer?

Thank you

[AEK]

Hi Jin

You can configure NTP on FAZ like this:

config system ntp
  config ntpserver
    edit 1
      set server "10.0.0.1"
    next
  end
  set status enable
end

Hope it helps.