FortiWIFI 60D does'nt reach interfaces activation

[RonanMael]

          Hi,

     What could be done when the device doesn't reach status lighted and wan interface up?

Is it possible to load image from usb? I tried with a 32Go partition in fat32 with an image.out (6.0.15-FWF_60D-v6-build0484-FORTINET.out) with no success. 

Best regards,

Gilles

it-service@ens-louis-lumiere

Vendor ID : Fortinet
CPU family : ARM9
CPU model : arm926ejs
CPU MHz : 800 MHz
Cache size : 64 KB
Memory : DDR SDRAM 2GB 1066MHz
Platform ID : FWF60D
Serial number: FWF60D4615018373
BIOS Build : FortiWiFi-60D (10:52-11.12.2014)
BIOS Ver:04000024

FortiGate 

[ebilcari]

Did you try with the backup firmware, in this article are shown the boot options.

[AEK]

Hello Gilles

You can try reinstall from TFTP server.

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Formatting-and-loading-FortiGate-firmware-...

[sw2090]

Yes you can do that. Firmware restore from USB is enabled by factory default with default filename image.out. So get a firmware image, put that on a USB Stick, rename it to image.out and then plug that into the USB POrt on your FGT and then reboot the FGT.

If you have a console cable connected you will be able to see on console that the FGT will take the firmware from the stick.

Same btw goes for the config too.