FortiSwitch - failing to retrieve ports

[funkylicious]

Hi,

Has anyone encountered when executing a command below to get this output?

Model FSW 124F-FPOE most of them and managed via FortiLink.

diagnose switch physical-ports summary

Portname Status Tpid Vlan Duplex Speed Flags Discard
__________ ______ ____ ____ ______ _____ ____________ _________
prt_switch_phyport_summary: unable to get port1(#1) status
prt_switch_phyport_summary: unable to get port2(#2) status
prt_switch_phyport_summary: unable to get port3(#3) status
prt_switch_phyport_summary: unable to get port4(#4) status
prt_switch_phyport_summary: unable to get port5(#5) status
prt_switch_phyport_summary: unable to get port6(#6) status
prt_switch_phyport_summary: unable to get port7(#7) status
prt_switch_phyport_summary: unable to get port8(#8) status
prt_switch_phyport_summary: unable to get port9(#9) status
prt_switch_phyport_summary: unable to get port10(#10) status
prt_switch_phyport_summary: unable to get port11(#11) status
prt_switch_phyport_summary: unable to get port12(#12) status
prt_switch_phyport_summary: unable to get port13(#13) status
prt_switch_phyport_summary: unable to get port14(#14) status
prt_switch_phyport_summary: unable to get port15(#15) status
prt_switch_phyport_summary: unable to get port16(#16) status
prt_switch_phyport_summary: unable to get port17(#17) status
prt_switch_phyport_summary: unable to get port18(#18) status
prt_switch_phyport_summary: unable to get port19(#19) status
prt_switch_phyport_summary: unable to get port20(#20) status
prt_switch_phyport_summary: unable to get port21(#21) status
prt_switch_phyport_summary: unable to get port22(#22) status
prt_switch_phyport_summary: unable to get port23(#23) status
prt_switch_phyport_summary: unable to get port24(#24) status
prt_switch_phyport_summary: unable to get port25(#25) status
prt_switch_phyport_summary: unable to get port26(#26) status
prt_switch_phyport_summary: unable to get port27(#27) status
prt_switch_phyport_summary: unable to get port28(#28) status
prt_switch_phyport_summary: unable to get internal(#29) status

[funkylicious]

thanks, i will try an upgrade to FSW 7.6.6

[ryuk6]

Of course it can, just enable dhcp server on the vlan interface (network>interfaces, not managed switch ports) you want to on the FGT, if you dont need anything fancy just go with the vsw.fortilink which is a subinterface with the vlan 1 tag.