Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FortiSwitch Interface
I currently have 2 FortiSwitches I'm running in stand-alone mode. The switches are connected from port 24 to port 24. I ran the following commands:
Config switch interface
edit port 4FFTFXXXXX
set native-vlan 10
set allowed-vlans 1-4094
set auto-discovery-fortilink disable
next
end
However, when I go and show that interface it still has the native vlan of 4094 listed. Any other port I can change with no issues. I've researched and can't find a reason it's not allowing me to change the interfaces that are connecting the 2 switches.
Any ideas or suggestions will be greatly appreciated.
https://vlc.onl/
Labels:
- Labels:
-
FortiSwitch
376
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you inter-connected the switches before configuring the ports 24?
AEK
AEK