FortiManager - Only show products we have for normalized interfaces?

[jdsauer77]

Question regarding FortiManager.

Is there any way to only show interfaces for the devices we have, as opposed to the entire product line? We typically use FGT 200F, 201F, 80F, and 60E/F devices. When I want to configure normalized interfaces, I have to wade through every model of device that Fortinet supports in that version of FMG. If I search just for the device type (e.g. 60F), find the port, then make a change, it goes back to the default view of everything and I have search again. When I'm working on building normalized interfaces for a bunch of devices, that can be difficult to deal with and I end up using port specific configurations instead of normalized ones. It would be great if I had the option to choose what devices I want to see in the normalized interface section of FMG and it was a setting that was saved.

[Anthony_E]

Hello,

Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.

Thanks,

[Anthony_E]

Hello,

We are still looking for someone to help you.

We will come back to you ASAP.

Regards

[Anthony_E]

Hello,

Could you please have a look at this document?:

https://docs.fortinet.com/document/fortimanager/7.6.0/administration-guide/396458/viewing-normalized...

[asrour · Accepted solution]

hi @jdsauer77 

try Edit Interface Map from device manager if that may be easier for you, it will create the per-device-mapping of the normalize interface