Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
kulas
New Contributor

FortiGate

Hi,

 

I'm just a newbie when it comes to Fortigate configuration. This may sound dumb question, so please bear with me :)

Is it possible to establish IPSec Site-to-Site VPN both sites uses PPPoE internet? Both PPPoE modem was set to bridge mode. We are trying to establish a VPN between Fortigate and Cisco RV345 (if I'm not mistaken with the model)

 

Any comments will be highly appreciated. Thank you.

3 REPLIES 3
Hosemacht
Contributor II

Hey Kulas,

 

just have a look in the cookbook:

http://cookbook.fortinet.com/ipsec-fortigate-cisco/

 

Regards

sudo apt-get-rekt

sudo apt-get-rekt
ede_pfau

Yes, that is possible. In fact, PPPoE is the most common WAN protocol over here and I've set up quite a few site-to-site VPNs over PPPoE links. If the site is not using a static IP address, you can use dynamic DNS gateway names in the VPN setup, even on both sides.

Ede Kernel panic: Aiee, killing interrupt handler!
Ede Kernel panic: Aiee, killing interrupt handler!
kulas
New Contributor

Thank you for this. We will look for the configuration of DynDNS on the Cookbook. Regards.

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors