Use custom source interface to exit, but the traffic will check the default route and exit through the found route interface, not the custom interface ip.
But after configuring the source ip, there is no problem.
Why is this?
config system ntp
set ntpsync enable
set type custom
set syncinterval 1
config ntpserver
edit 1
set server "10.0.0.17"
next
end
set source-ip 10.0.64.114---------------Can
end
------------------------------------------------------------
config system ntp
set ntpsync enable
set type custom
set syncinterval 1
config ntpserver
edit 1
set server "10.0.0.17"
set interface-select-method specify
set interface "port1"----------------------Can't
next
end
end
port1=10.0.64.114
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Created on 07-02-2024 07:43 AM Edited on 07-02-2024 07:44 AM
There is no specific route than those 0/0 routes. Do you see all four routes in "get router info routing-t detail 10.0.0.17"?
Then do you happen to have any policy routes or SD-WAN rules?
But if you set a specific route like,
config router static
edit 0
set dst 10.0.0.17/32
set gateway 10.0.64.x <-- GW IP
set device port1
next
end
you would accomplish what you want.
Toshi
Hi @Zhuo
The "set interface-select-method" command is used when you have more than one available routes to the destination like in the case of SDWAN and where you want self-orginating traffic to consider SDWAN rules/routes. Here with your setup I am not able to see any route available via the Port1 to reach your NTP server. So specifying that interface will not work as expected. The solution is to use "set source-ip" so the traffic will always leave FGT using this IP as source even though it exit out of Port2 as per your routing.
Best Regards,
Saneesh
Maybe a knit-picking, but this KB describes only "...(DNS, FortiGuard, RADIUS, LDAP)..." instead of "...(DNS, FortiGuard, RADIUS, LDAP, etc.)..."
Does this apply to NTP traffic as well?
Toshi
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1720 | |
1093 | |
752 | |
447 | |
234 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.