- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FortiGate AON SFP + AVM Fritz!Box
Hello,
can I use the SFP module of an AVM Fritz!Box in the FortiGate 80E?
I already had the module installed in the Fritz!Box once, but I can't get a connection. In the AVM, the module works and also establishes a connection.
Or does anyone here have experience with AON SFP modules to connect fiber Internet in Germany?
Greetings
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Although many SFP brands should work but in case you have an issue I guess you won't be supported.
At least you can try, it will not break your FGT.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Good morning,
I was able to put the included module of the AVM Fritz!Box into operation in the FortiGate. It took only two - three minutes until the connection was established.
This is the AON module from AVM.
get system interface transceiver
Interface wan1 - Transceiver is not detected.
Interface wan2 - SFP/SFP+ (1.3G)
Vendor Name : ACAL BFi
Part No. : ABSFBLNO55-20DAC
Serial No. : ....
SFP-DSL MAC :
Optical Optical Optical
SFP/SFP+ Temperature Voltage Tx Bias Tx Power Rx Power
Interface (Celsius) (Volts) (mA) (dBm) (dBm)
------------ ------------ ------------ ------------ ------------ ------------
wan2 42.5 3.32 22.48 -4.4 -6.0
++ : high alarm, + : high warning, - : low warning, -- : low alarm, ? : suspect.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm going to try the same with the XGS-PON SFP+ from AVM Fritz
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@tuky could you share with me what's the part number you can read when you install the XGS-PON SFP+ from AVM Fritz in the fortinet ?
Thx
