FortiGate 40F Dual WAN failover check

[DD-UT]

We have a FortiGate 40F with two WAN lines.

I know there are knowledge base articles on how to configure fail over without load balancing.

However how do I check how it is configured at this time?

What I want is fail over without load balancing.

[hpenmetsa]

Hi, there are multiple ways to configure the failover between the WAN interfaces. I am sharing a few knowledge-based articles.

You can check link monitor status to check if there is any existing config.
diagnose sys link-monitor status

https://community.fortinet.com/t5/FortiGate/Technical-Tip-Redundant-Internet-connection-without-load...
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Dual-WAN-Failover-on-FortiGate/ta-p/397565
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Configuring-Failover-with-Policy-Routing-o...