Hi, recently updated the firmware of my FortiGate 40F to v7.2.3 and since then my IPSec Dial-in VPN doesn't seem to work properly anymore. My FortiClient connects okay, but the IP is blank, and there are no packets being received.
I've checked the System logs, and it shows my VPN User connected Successfully, and was assigned an IP (I'm sure its lying) which is confusing me.
DHCP is disabled on the router, rather instead the IPSec assign an IP from a specified range (with a pool of 200 IPs). Split tunneling is disabled, and two policies have been created.
1x Incoming VPN to LAN - Everything is allowed
1x Incoming VPN to WAN - Everything is allowed
I can't see what the issue is, and when I run the command "diagnose vpn ike gateway list" it doesn't show anything in the console. I also tried "diagnose debug enable" and doesn't do anything either
Hello
How do you have the DHCP server configured? Do you have DHCP over IPSec enabled on the phase2 of the tunnel?
Can you do a " diagnose sniffer packet any " port 67 or port 68 or arp" 4" ?
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2023 Fortinet, Inc. All Rights Reserved.