FortiAnalyzer Bandwidth Graphic

[Dntcap]

Hi,

We are have some issues about interface Bandwidth Graphic at Fortianalyzer.We are using 5.2 version in Fortigate and Fortianalyzer.

The graphics at fortigate is ok, showing the correct in and out packets that are passing trough a specific interface.

When we run the Bandwidth Graphic Summary at FortiAnalyzer, it shows the amount of traffic, neither we have filtered the correct interface.

We need to create a report at FortiAnalyzer to show exactly the same information that is viewed at interface Bandwidth graphic in fortigate.

Is there any tip to solve this issue ?

[hzhao_FTNT]

Could you specify your FAZ version and describe how you apply the filter? I tried to apply srcintf=wan1 on chart "Bandwidth Summary" on 5.2.7, no issue found.

[Dntcap]

We are using 5.2.4.

There is no issue about the filter itself.

The issue is about report's result. The information that is generated using FAZ ( Bandwidth Summary ) is different than  FGT ( Interface History ).

[pdavisedu]

We're seeing the same issue with 5.2.7. The only place the problem seems to exist is on the -webfilter graphs for bandwidth; the traffic graphs don't seem to have the same issue as I was able to use that to get a workaround in place for the time being by creating a set of custom graphs.

We're using the "Web Usage Summary" as the basis for the reports in question.