Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
amilojevic
New Contributor II

FortiAP Boot problem

Hello everyone,

I have an FortiAP 221E that cannot boot. After I tried to upgrade, it stops working. When I connect him to power (AC or POE) green light is on, no blinking just turn on immediately and stay on. I cannot connect via LAN becouse it start, work few seconds and go down, no cable connected message on PC. 

I tried factory setting reset, no help. 5-10sec to enter config mode, no wifi (FAP-confgi-Serial). There is no console on device. 

Has anyone has this problem. How to connect to AP and install new firmware?

1 REPLY 1
gfleming
Staff
Staff

Sounds like an RMA is needed. Contact TAC to sort it out.

Cheers,
Graham
Announcements
Check out our Community Chatter Blog! Click here to get involved
Labels
Top Kudoed Authors