I have replaced the FortiAP 221c from Fortigate 100F to fortigate 80E. I was connected on 100F but when i connect the same AP to 80E it is showing as discovery AC and stuck in connecting mode. I am able to connect reach the device and able to https also but not able to connect to fortigate 80E at new location.
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
It may be a firmware incompatibility issue, you can check in the Compatibility Matrix the firmware versions of FortiAP and FortiOS.
There is also a note that applies for this AP:
*These FortiAP models and versions do not support strong ciphers. To allow connections, input the following commands in the FortiOS CLI:
For FortiOS 7.0.0:
config system global
set ssl-static-key-ciphers enable
set strong-crypto disable
end
For FortiOS 7.0.1+:
config wireless-controller global
set tunnel-mode compatible
end
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1603 | |
1048 | |
749 | |
443 | |
210 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.