Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
Duminda
New Contributor

Forti Cluster with LACP connect CISCO SVI Switch

Hi Kindly advise we have a requirement to configure as below, 

 

Forti Member1 > Switch 1

Forti Member1 > Switch 2

Forti Member2 > Switch 1

Forti Member2 > Switch 2

 

According to the physical connection, we have 4 connections to the Cisco Switch SVI environment. 

Cisco side we need to correct one port channel, can someone advise if is it possible to do this? do i need to modify the connection configuration? 

 

Thank you,

Duminda. 

 

2 REPLIES 2
Anthony_E
Community Manager
Community Manager

Hello Duminda,

 

Thank you for using the Community Forum.

I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.


Regards,

Anthony-Fortinet Community Team.
ebilcari
Staff
Staff

Hello,

I suppose that the two Cisco switches are in a single cluster and allow to aggregate those 4 ports (2 port of each switch ) on a single LAG using LACP.
If yes you can treat them as a single switch and refer to this article: https://community.fortinet.com/t5/FortiGate/Technical-Tip-LACP-behavior-in-an-HA-cluster/ta-p/195163
or the configuration guide: https://docs.fortinet.com/document/fortigate/6.0.0/handbook/207052/ha-with-802-3ad-aggregate-interfa...

- Emirjon
If you have found a solution, please like and accept it to make it easily accessible for others.
Labels
Top Kudoed Authors