Facing "No disk requirements found" error while installing FortiSIEM collector on KVM

[Rachit_2509]

While installing the collector on KVM, I got this error saying "Error: No disk requirements found for platform 'FSIEM UNKNOWN' and role 'collector'. Please check the configuration." 

Trying to install the 7.3.3 collector image. And the file type is "qcow".

[Richie_C]

Hi @Rachit_2509 

From your output i can see that you have a 200G disk. I have seen in the past that you need to use the actual values specified in the sizing guide. Could you try again with a 100G disk? If there is a requirement for a bigger disk, you could then expand the disk later. This can be done with the following article.

https://community.fortinet.com/t5/FortiSIEM/Technical-Tip-Extend-the-opt-partition/ta-p/303184

Regards

[Rachit_2509]

Hi @Richie_C 

We also tried with 100G disk, but same error is getting prompted. We are getting this on runnning configFSM (after selecting the timezone)