FTM Push configuration for branch office

[Tutek]

Hello,

how should I configure ftm push feature for branch office with RIA - remote internet access through main office fortigate, the diagram is as below:

FGT-branch # config sys ftm-push

FGT-branch (ftm-push) # get
server-port : 4433
server-cert : Fortinet_Factory
server-ip : 0.0.0.0
server :
status : disable

FGT-branch (ftm-push) # set status enable

FGT-branch (ftm-push) # end
Missing server address.
object check operator error, -56, discard the setting
Command fail. Return code -56

As I understand I need to configure on branch main office's WAN IP in the ftm-push settings, because ftp-push call will arrive at the main office WAN then should be route back to 80F - right?

[Tutek]

is there any way to configure two wan ip addresses for ftm-push service, if one isp will have connection down then I could connect using another ips

server-ip : 0.0.0.0

[pminarik]

Multiple IPs cannot be selected. You could try set server <...> and use an FQDN which resolves to both of your WAN IPs, but I have never tried this, so I cannot say if this will work or not.