- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FTM Push configuration for branch office
Hello,
how should I configure ftm push feature for branch office with RIA - remote internet access through main office fortigate, the diagram is as below:
FGT-branch # config sys ftm-push
FGT-branch (ftm-push) # get
server-port : 4433
server-cert : Fortinet_Factory
server-ip : 0.0.0.0
server :
status : disable
FGT-branch (ftm-push) # set status enable
FGT-branch (ftm-push) # end
Missing server address.
object check operator error, -56, discard the setting
Command fail. Return code -56
As I understand I need to configure on branch main office's WAN IP in the ftm-push settings, because ftp-push call will arrive at the main office WAN then should be route back to 80F - right?
- Labels:
-
FortiGate
- « Previous
-
- 1
- 2
- Next »
Created on 12-08-2022 10:39 AM Edited on 12-08-2022 10:39 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
is there any way to configure two wan ip addresses for ftm-push service, if one isp will have connection down then I could connect using another ips
server-ip : 0.0.0.0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Multiple IPs cannot be selected. You could try set server <...> and use an FQDN which resolves to both of your WAN IPs, but I have never tried this, so I cannot say if this will work or not.
- « Previous
-
- 1
- 2
- Next »