Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
a_l_b_erto
New Contributor

FGR60 port(n) and WAN in Hardware Switch

Hi all, 

 does it possible to create on FGR60 and Hardware Switch interface with port(n) and WAN(n) port? I'm asking because I don't have the possibility to verify directly.

 

Best Regards

Alberto 

3 Solutions
AEK
SuperUser
SuperUser

WAN port and port# are the same. It should be possible to make a hardware switch.

AEK

View solution in original post

AEK
Toshi_Esumi
SuperUser
SuperUser

AEK

Thanks for sharing, Toshi.

I can see the following:

--------

The SOC4 ISF allows you to use the command config system virtual-switch to create a virtual hardware switch that can include any front panel interface connected to the SOC4.

--------

That should confirm that we can create a hardware switch with WAN4 and port#, since all are connected to SOC4, right?

AEK

View solution in original post

AEK
4 REPLIES 4
AEK
SuperUser
SuperUser

WAN port and port# are the same. It should be possible to make a hardware switch.

AEK
AEK
Toshi_Esumi
SuperUser
SuperUser

AEK

Thanks for sharing, Toshi.

I can see the following:

--------

The SOC4 ISF allows you to use the command config system virtual-switch to create a virtual hardware switch that can include any front panel interface connected to the SOC4.

--------

That should confirm that we can create a hardware switch with WAN4 and port#, since all are connected to SOC4, right?

AEK
AEK
a_l_b_erto
New Contributor

Thanks to all for the contribution! I'll do it as soon I have access to the firewall for configuration!

Best Regards

ALberto

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors