FGR60 port(n) and WAN in Hardware Switch

[a_l_b_erto]

Hi all, 

 does it possible to create on FGR60 and Hardware Switch interface with port(n) and WAN(n) port? I'm asking because I don't have the possibility to verify directly.

Best Regards

Alberto 

[AEK · Accepted solution]

WAN port and port# are the same. It should be possible to make a hardware switch.

[Toshi_Esumi · Accepted solution]

I have to assume it's FGR-60F though.
https://docs.fortinet.com/document/fortigate/7.6.0/hardware-acceleration/754739/fortigate-rugged-60f...

Toshi

[AEK · Accepted solution]

WAN port and port# are the same. It should be possible to make a hardware switch.

[Toshi_Esumi · Accepted solution]

I have to assume it's FGR-60F though.
https://docs.fortinet.com/document/fortigate/7.6.0/hardware-acceleration/754739/fortigate-rugged-60f...

Toshi

[AEK · Accepted solution]

Thanks for sharing, Toshi.

I can see the following:

--------

The SOC4 ISF allows you to use the command config system virtual-switch to create a virtual hardware switch that can include any front panel interface connected to the SOC4.

--------

That should confirm that we can create a hardware switch with WAN4 and port#, since all are connected to SOC4, right?

[a_l_b_erto]

Thanks to all for the contribution! I'll do it as soon I have access to the firewall for configuration!

Best Regards

ALberto