i have setup STMP server under Settings -> Email Service, for sending emails alerts for our FG100F.
but it does not seems to work.
what else must I enabled on the firewall.
firmware version is 7.2.5
Solved! Go to Solution.
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Hi @yeowkm99,
If it doesn't work, please collect debugs mentioned in this article: https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-Email-alert/ta-p/199344
Regards,
See below and refer to the section "Alert emails" almost at the bottom. I thought it was in GUI as well but the doc says it's available in CLI.
https://docs.fortinet.com/document/fortigate/7.4.2/administration-guide/526019/email-alerts
Toshi
Hello @yeowkm99
I understand that you are trying to configure the email alerts for FortiGate.
Please refer this document which has detail explanation of settings for email alerts.
https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-configure-alert-email-settings/ta-p...
Hope this helps!
The default has nothing enabled. You need to enable something.
FortiGate-70F (setting) # show
config alertemail setting
end
FortiGate-70F (setting) # get
username :
mailto1 :
mailto2 :
mailto3 :
filter-mode : category
email-interval : 5
IPS-logs : disable
firewall-authentication-failure-logs: disable
HA-logs : disable
IPsec-errors-logs : disable
FDS-update-logs : disable
PPP-errors-logs : disable
sslvpn-authentication-errors-logs: disable
antivirus-logs : disable
webfilter-logs : disable
configuration-changes-logs: disable
violation-traffic-logs: disable
admin-login-logs : disable
FDS-license-expiring-warning: disable
FSSO-disconnect-logs: disable
ssh-logs : disable
FDS-license-expiring-days: 15
Toshi
config alertemail setting
set username "email@email.com"
set mailto1 "myemail@email.com"
set email-interval 2
set IPS-logs enable
set configuration-changes-logs enable
set admin-login-logs enable
end
Hi @yeowkm99,
If it doesn't work, please collect debugs mentioned in this article: https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-Email-alert/ta-p/199344
Regards,
enabling source-ip did the trick.
i managed to test since my firewall is over ipsec tunnel at remote site.
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1696 | |
1091 | |
752 | |
446 | |
228 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.