- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
FG-90G to FS-424E-Fiber Uplink 10G+1G
Hello,
we have two FS-424E-Fiber as core switches and two FG-90G as active/passive.
As we don't have enough 10G ports, we can only connect each Forti with 1x10G + 1x1G to the two core switches via MCLAG.
The problem is that the traffic should of course primarily run over the 10G connection, the 1G only as a passive backup.
If I add both interfaces to the Fortilink and deactivate the FortiLink split interface, it is not guaranteed that the 10G connection is actively used.
If I activate the FortiLink split interface, both are actively used.
Is there a possibility that I have overlooked?
Thanks and regards
Björnar
- Labels:
-
FortiGate
-
FortiSwitch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Bjornar,
Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.
Thanks,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
One of the criteria for LACP to work is having the same link speed, so using a different speed isn't supported.
Sachit Das
ETAC Engineer
Wifi-Switching – International Support
![](/skins/images/03B6F9D09B0B73D4E0068FD5D5412A2D/responsive_peak/images/icon_anonymous_message.png)