Hi Folks,
I am facing issue with FG 60D (V6.0.12) , from Firewall client not able to receive IP address even though DHCP configured. Now we did firewall reset to factory settings and still client not able to receive any IP address. Help me out to resolve this issue.
Note : My both WAN1 and WAN2 ports are not working .
Factory default on a FGT usually is: internal (port) 1-n is one switch with 192.168.1.99/24 and DHCP Server on.
WAN1/2 are role wan with dhcp client enabled but no dhcp server enabled.
Also there is one policy 192.168.1.0/24 to the internet.
Also you could connect to the serial console port and look at the interface config at cli:
show system interface ? (Typing the "?" in the end will cause the cli to list all interfaces with ip config).
--
"It is a mistake to think you can solve any major problems just with potatoes." - Douglas Adams
Thanks for reply!!
In my case WAN1 and WAN2 both ports are not working physically , I connected console using USB MGMT . Let me know in this case how i can configure further.
How do you determine that WAN1 and WAN2 are not working physically?
You will only get an ip on port1-n as only the switch containing them per default has a dhcp server up and running.
WAN1 and WAN2 will not give you an ip but will try to get themselves one via dhcp (except if you enable a dhcp server on them).
--
"It is a mistake to think you can solve any major problems just with potatoes." - Douglas Adams
Saludos estimados , tengo el mismo problema. en vesz de darme la ip en el rango de 192,168.1.1-255 la que me da es 169.254.6.236
User | Count |
---|---|
2522 | |
1347 | |
794 | |
639 | |
455 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2025 Fortinet, Inc. All Rights Reserved.